Preparing to Use Your Pace Clock for the First Time

 

1. Remove clock from shipping carton. Lay clock flat with the lens side facing up. Remove four screws from clock lens. Set the lens aside.

2. Remove foam clock hand protection from the Minute Hand (black) and the Second Hand (red).

CAUTION:

Do not bend or twist the hands. Mount the Second Hand assembly onto the needle shaft located at the center of the exposed motor shaft. Slide the hub over the needle using light pressure. The hub should not be forced all the way down or theclock will not operate.

3. Gently push on center hub of the Second Hand to make sure it is properly seated.

4. Open the back access panel of the clock. Locate the battery motor and copper contact that hangs down from the On/Off switch. Install the AA battery into the proper position. Carefully slide the copper contact between the negative side of the AA battery and the metal contact of the battery motor.

5. Check the On/Off switch located on the top of the clock to see that it is operating properly. The clock may be turned on and off only; there is no automatic reset. The second hand may be reset manually by opening the back cover plate and turning the small dial located on the battery motor housing.

6. If, after testing the On/Off switch, the clock is not working, check to see that the On/Off connector is properly and firmly seated between the battery and negative-side clip. Also check the motor to see if the master switch is in the On position.

7. Remove protective film from the clock lens and set lens in the same position with the four holes on the lens matching up with the four located on the clock housing. You may have to rotate the lens to find the correct position. Re-install the four screws.